Power UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is designed exclusively for that little lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit continues to be widely utilised inside the field of logistic gadgets for instance minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled by the solenoid valve using the velocity managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This electrical power unit is created solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve along with the pace managed from the adjustable needle valve. When the lift rises to a higher positoin, however the power supply is reduce, the reducing motion is controlled through the manual override function.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This electrical power unit is created solely for that significant lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve along with the speed controlled by a stress compensated flow handle valve.
Power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is made exclusively for that substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as speed controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is reduce, the lowering movement is managed by the manual override function.
Special Notes
one. This electrical power unit is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned prior to set up of the energy unit.
three. Viscosity of your oil shoud be 15~46 cst,which should really also be clean and absolutely free of impurities.N46 hydraulic oil is suggested.
four. Oil modifying is required immediately after the original 100 operation hrs,afterwards the moment every 3000 hours.
five. The electrical power unit shown is created to be mounted vertically.