ep

December 26, 2019

The EP Greenhouse geared motor is a compact and lightweight reduction gear driver with a built-in limit switch system that’s ideal for assembly of a locally available electric motor. The reducer is used in manually-controlled or climate-controlled ventilation and screen systems in greenhouses. The quick and easy-to-install EP gear reducer is rainproof and windproof. The reducer has a high protection class (IP65) and can be used in an ambient temperature of 0-60 °C.

The low-noise gear motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny ensures that the drive shaft is usually locked when the decrease reducer is not running. The completely sealed reduction gear driver has an growth chamber with a diaphragm to keep the gear essential oil at a minimal pressure under all conditions, even at high temperatures. Thanks to the use of an expansion chamber, the gearbox can be installed in any placement. There are no restrictions, since there is no dependence on a bleed connect. The sealed reduction gear driver keeps the gear oil of the reducer in optimum condition because of its entire operating lifetime. The geared motor is ideal for discontinuous use, working class s3-30%, with a maximum activation period of 25 minutes.

The Gear box reduction geared motor comes with an FT85 motor assembly flange, to which a suitable IEC standard motor can simply be installed (EN 50347).

The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed in an integrated chamber and is usually enclosed by an impact-resistant plastic-type material cover. The limit switch system is accessible and easy to adjust. The limit switch system’s optimum switching range is usually 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The geared motor comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The reducer for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of software of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, optimum activation time 25 moments.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC regular motor (EN 50347).
Maximum switching selection of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).