Material Managing Electrical power UNIT 1
This power unit is intended to the fork lift marketplace, consisting of remarkably productive gear pump, DC motor, manual raise and reduce valve, tank, ect. The up and down movement are managed by the lever on the guide release valve, that’s outfitted with an electric switch to activate the motor. The lowing pace is controlled through the strain compensated movement management valve.
one. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean every one of the hydraulic elements concerned prior to set up of the power unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst, which must also be clean and absolutely free of impurities, N46 hydraulic oil is advised .
four. Oil changing is needed immediately after the first a hundred operation hrs, afterwards as soon as every single 3000 hours.
5. The power unit shown is created to be mounted horizontally.
Material Managing Power UNIT two
This energy unit attributes energy up gravity down circuit. Activate the begin solenoid to start out the motor to lift the machine. The lowing movement is activated from the solenoid valve with all the reducing velocity controlled from the stress compensated movement management valve. Goods of this series may be broadly utilized in the market of logistic units which include fork lift, mini lift table, etc.
1. The duty of this energy unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean each of the hydraulic parts concerned prior to mounting the energy unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst,which ought to also be clean and cost-free of impurities, N46 hydraulic oil is advised .
4. Oil altering is needed following the original a hundred operation hrs,afterwards as soon as every single 3000 hours.
5. The energy unit really should be mounted horizontally.