Consisting of the pressure balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this electrical power unit is built to operate material handling products. The lowering motion is achived from the solenoid valve with the lowering pace controlled by an adjustable needle valve. The left and proper functions are equipped using a dual pilot operated test valve and cross-over relief valves.
Remark: Please seek the advice of our income engineer for the distinctive pump displacement, motor power or tank capability.
1. This power unit is of S3 duty cycle, i.e.,non-continuous operation,30 seconds on and 270 seconds off.
2. Clean each of the hydraulic parts concerned before installation of the energy unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which should really also be clean and free of charge of impurities.N46 hydraulic oil is advised.
4. This power unit must be mounted horizontal.
five. Check the oil degree in the tank after the first start of the electrical power unit.
six. Oil changing is required just after the original 100 operation hours, afterwards once just about every 3000 hours.